-
Foxflash Read Audi A6 EDC17CP14 Failed, Tprot Bypassed in Bench Mode
جمعه 4 آبان 1403 05:49
Audi A6 2.0l tdi 2010 Possible to read and write with foxflash via obd? Tried to read via OBD but failed. It is written, bench or boot mode. 2010 has Tprot. Only bench mode to bypassing tprot. Bench write and read ok. Check bench pinout here http://www.pcmtuner.org/foxflash-read-and-write-audi-a4-2-0-edc17cp14-ecu/
-
Foxflash Reads Mazda CX-5 Denso SH1K ECU in 30 Minutes
جمعه 4 آبان 1403 05:47
Foxflash read and write Mazda CX-5 Denso ECU SH1K via OBD successfully. OBD Read/Write worked fine. Photos added. Read time takes 30 minutes. But it works. Select ->OBD driver ->Mazda ->Mazda CX-5 ->2.2 SKYACTIV-D Denso SH1X *CAN Voltage 14V. EGR Off.
-
Foxflash Supports Ford Transit DCU101 ECU with OBD Protocol
جمعه 4 آبان 1403 05:45
It is a Ford Transit Visteon with DCU101 ECU. Foxflash will read and write this ECU via OBD. It is DCU 101 but protocol DCU 102/108 works. Select OBD drive ->Ford ->Transit ->2.2/2.4 TDCI E4 FOMOCO VISTEON DCU 102/108 *CAN Read ok via OBD. Write OK via OBD. Checksum by foxflash. EGR + DPF OFF. www.iecutool.eu
-
FormulaFlash 1.0.0.7: ME788 BSL Mode and IMMO Off Features
دوشنبه 30 مهر 1403 09:20
FormulaFlash released new software 1.0.0.7 on October 21st, 2024. 1. Adds ME788 BSL mode, read, write, clone, checksum and IMMO Off, idle speed adjustment, power upgrade (World’s first) 2. New checksum: Simos 8.x, MSD80, MSD81, MSD85, MSD87 Upcoming updates: 1. ME7.8, ME797, ME7971 virtual reading and writing,...
-
Fixing U2A200 Fault Code After Audi SCR Off with Foxflash
دوشنبه 30 مهر 1403 07:23
Problem: Successfully read and write Audi Bosch Md1cs004 ECU with Foxflash . SCR off. But scanner shows fault code U2A200 after scr off. Reductant quality sensor no communication. How to fix it? Solution: Just disconnect adblue pump. Disconnect adblue if the fault doesn’t disappear do dtc off solution as well. User...
-
How to Read and Write Yamaha MT 07 2021 R5F10DMFJ Chip
دوشنبه 30 مهر 1403 07:21
It is a Yamaha MT 07 2021 with R5F10DMFJ chip. How to read/write this massive chip? What tool can be used? Here is the clue. UPA 1.3 cannot read, you need pogrammer for this mcu smok, xtool, carprotool, CG100/ CG100X , vvdi prog ect Here is the pinout wiring connection. Feedback: I finally bought a CG100x from...