How to Solve Foxflash Read Fail on Ford SID211
Problem: It’s a Ford Transit Custom 2017 with SID211 ECU, Foxflsah reads id ok but reading error. Any idea?
Solution:
Charge maintenance at 14V+.
Read and clear all defaults in your ecu and try. If not good repeat this and remove the positive connector on your battery for 5min and try again.
Normally reading is good.
User report:
1).
Transit Custom 2018 SID211
OBD password ok
OBD read/write
ok
checksum by foxflash.
2).
SID211 2017 Ford transit/tourneo 2.0tdci, obd2 read and write all ok. 12 mins write, 5 min read.
How to Read Write Fiat MJD 9DF ECU via Foxflash
Foxflash new user feedback today:
Fiat Marelli MJD 9DF ECU.
Tired obd2 didn’t work
Did it via bdm and it
was quite easy .
Read 20–25 minutes.
Write 20–25 minutes.
Checksum
correction via foxflash
Bit of work but very smooth.
lots of heat, lots of patience.
Foxflash usually does MJD 9DF full read and write via OBD, if it is Hw002 read full system, Write obd, or BDM mode. FLEX does this hw002 full obd.
Best Tool to Clone Renault DC4 Gen1 TCU: X-prog3 or Foxflash
Renault Continental DC4 Gen1 gearbox TCU cloning review:
Renault Clio 1.2 88KW 2014 Gearbox Cloning.
Gearbox type: Continental DC4
Gen1
Read ok on bench.
Write failed.
This specific version is encrypted and cannot be cloned with Foxflash. Also Foxflash Reads and Writes only Maps on Flash, no Eeprom!
Done with Launch PAD V Elite with X-prog3 extension, or use the Launch X431 ECU programmer standalone.
Read on bench ok.
Write on bench ok.
Flash and Eeprom perfectly cloned!
One tool cannot do all.
Solution for Foxflash Login But No Program Launch
Problem: Failed to run Foxflash software after login?
How to fix
program not starting after this screen?
It’s Windows 10 system.
Solution:
Make sure foxflash is plugged in and showing as dfb in Device Manager.
Kill the app through task manager.
Unplug FoxFlash USB.
Open FoxFlash
manager.
Click Activate.
After the screen process started plug-in the USB
cable and press OK.
After that open FoxFlash.
If the problem exists, contact your customer service.
Foxflash V1.4.3.1 Asks for Activation After Update
Problem: I have foxflash manager version 1.4.1 when instart it it says newer update is available 1.4.3.1. After update, it asks to contact the vendor to activate. Do I need to activate it again?
Solution:
Yes, in this case, you need to contact us to activate Foxflash.
Send the device serial number and register email to us to activate software via Teamviewer.
Contact
Whatsapp:+8618046220975
Email:Sales@iECUtool.eu