Foxflash guide to boot-read and clone Renault SID306

Renault SID306 ECU cloning is done with Foxflash programmer.

Continental Sid306 Infineon TriCore SAK-TC1766 boot mode clone ecu.
Need attention for pinout because very small in ecu pin.

Cloning cannot be done on bench.

Read in boot ok.

Write in boot ok.

Checksum by foxflash.

Better keep power supply 12V+.

How to Read and Write Volvo SID803A ECU with Foxflash

Foxflash new user feedback:

This is a Volvo ECU.

Siemens sid803A.
Done via foxflash.

Read ok.

Write ok.

Checksum by foxflash.

Note:
It was under full system.
Not in bench section.

All done under 5 min.

It worked without any problems.

How to Solve Foxflash DQ250 Gearbox Read Problem

Problem: Foxflash failed to read VW DQ250 gearbox from Golf6 GTi on bench.
Error no Flash, no Eeprom, no Backup?

Solution:Your voltage is too low.

You’re running way under 12v and doing DSG gearbox. Add 13volts and some amps. Then try again.

On these 02E Foxflash works better than PCMflash. You need OBD to DSG socket cable and manual power switching. Or use godiag ggt107 gearbox adapter.

How to Read Write Mercedes SIM266 ECU with Foxflash

Foxflash read and write Mercedes B170 Siemens sim266 ECU in BDM successfully.

Siemens sim266
Mercedes B170
Bdm mpc55x
Read ok.

Write ok.

Checksum with foxflash.

Keep voltage 13V.
By foxflash all took around couple of minutes.

How to Read and Write Volvo DENSO MB279700 with Foxflash

Foxflash new user report:

Volvo XC60 DENSO MB279700 ECU.
Did it again via foxflash.
Read unlock ok.
Write ok.
EGR OFF.
Note: turn on off a couple times.
When reading and unlock till you start procedure started
See a lot people get error. Those who get error have something like 11.9–12.3volts. It can be done. just try.