Padflash ecu programmer read and write MAN truck Bosch EDC7C32+ MPC561 successfully.
Mode: OBD mode.
Select Car- DAF- CF75- Cummins Bosch EDC7C3.
Read connection instructions, connect PADFlash with vehicle via OBD cable.
Hit ECU Data to connect to the ECU.
On connection ECU details are shown.
Create a backup of this ECU.
Open modified data.
Write data.
Done.
PADFlash ecu programmer will read and write Mercedes Delphi CRD3.10 ECU via OBD and Bench mode.
Run PADFlash Updater manager tool.
Hit Search and find pinout for
CRD3.10.
Connect the bench cable to ECU.
Connect the bench box to
PADFlash.
Please use the correct gender adapter. Tool has 1 for OBD cable and another for bench box.
In PADFlash Updaters, hit "Activate FW" to download a
license key. (For each ecu we want to work with.)
Hit
"Activate" to activate the tool.
Click OK when you see the
tool login.
Run PADflash software.
Select driver.
Select
Bench mode- Bench CRD3.x Mercedes Tricore TC1793/97- Bench CRD3.X Mercedes,
press Next.
Read the instructions, use the correct gender adapter.
Connect to the ECU.
On connection ECU details are shown.
Create a backup of this ECU.
Then we can write modified data to the
ECU.
Run PADFlash Updater manager tool, hit "Activate FW"
then "Activate" to login.
Select driver Car- Mercedes- car model- drivre
Delphi CRD3.x TC1797
Connect, Read ECU data and save.
Open file and load modified data.
Write File.
OBDSTAR DC706 new user feedback:
It is a VW Bosch ME7.5 ECU, Part number 0261207619.
it doesn’t give access.
Entering through ME7.5.10 kline menu even though the ecu is 80 pins still does everything ok.
Function:
Read EXT eeprom 95040
Read EXT flash 29F400BT
Write EXT eeprom
95040
Write EXT flash 29F400BT
Read pin code
IMMO ON/IMMO OFF
Write
VIN.
Problem:
Foxflash failed to read VW Simos 18.1 tc1792 ecu in boot mode. I have 14.5V And checked Pinout 2 times. There’s always this error (no response with ECU) and wake error. Any solution?
Solution:
1). Voltage issue.
Set to 13v. Too much voltage at the moment if 14.5v.
Some
ecus need very specific voltage, start allways from 12v and try again by raising
voltage in steps of +0.5v.
So 12v read, 12.5v read ,13v read and so on.. up
to 14v. Rare cases need to go above 14v.
2). Pinout issue.
You need to change the arrangement of the resistors.
Because at this point on one pin where you are supposed to have 1k ohm you have 2k ohm.
Will Padflash programmer read and write Ford Siemens VDO SID902 ECU?
Yes, PADFlash will read and write SID902 via Jtag.
SID902 is not possible to do on bench mode. Only Jtag or OBD. PADFlash can do it via Jtag mode.
PAD Flash software will show you jtag wiring diagram.
If need to read SID902 ECU via OBD, choose Alientech KESS3, Flex or Autotuner.