Problem:
How to solve this problem. after installing new Foxflash version 1.4.2 on windows 7?
Error
"Unable to Check Server". I always use Windows 7, this happened after the
update.
Solution:
This message will appear on Win7 system. On Win10 it does not appear.
Some use it on Windows 7, getting this message for a few days, but FoxFlash
will load without a problem. Try running it without pressing OK. If it
doesn’t work, restart the computer and try again despite this
message.
After a few days this message didn’t come out again and it
still works well with the latest version 1.4.2 of FoxFlash.
We strongly recommend installing foxflash software on Win10 or Win11 systems.
Foxflash read and write Iveco STRALIS EDC17CV41 ECU on bench successfully.
To read and write use the following driver:
→ BENCH MODE
→ Iveco
→
TC1797 — Iveco
→ EDC17 CV41
Read ok,
write ok
Checksum by foxflash.
EGR + DPF off.
Check pinout here
http://www.pcmtuner.org/edc17cv41-pinouts-to-pcmtuner-and-foxflash/
Audi A6 2.0l tdi 2010 Possible to read and write with foxflash via obd? Tried to read via OBD but failed.
It is written, bench or boot mode.
2010 has Tprot. Only bench mode to bypassing tprot.
Bench write and read ok.
Check bench pinout here
http://www.pcmtuner.org/foxflash-read-and-write-audi-a4-2-0-edc17cp14-ecu/
Foxflash read and write Mazda CX-5 Denso ECU SH1K via OBD successfully.
OBD Read/Write worked fine. Photos added. Read time takes 30 minutes. But it works.
Select ->OBD driver
->Mazda
->Mazda CX-5
->2.2
SKYACTIV-D Denso SH1X *CAN
Voltage 14V.
EGR Off.
It is a Ford Transit Visteon with DCU101 ECU. Foxflash will read and write this ECU via OBD.
It is DCU 101 but protocol DCU 102/108 works.
Select OBD drive
->Ford
->Transit
->2.2/2.4 TDCI E4 FOMOCO VISTEON DCU 102/108
*CAN
Read ok via OBD.
Write OK via OBD.
Checksum by foxflash.
EGR + DPF OFF.