How to use Foxflash to read BMW EDC17CP45
Problem:
Foxflash failed to read BMW F11 Bosch EDC17CP45 ECU via OBD?
Solution:
Read it on bench. It is safe.
BMW EDC17 none of them worked on OBD.
Read obd is vr. Original file not found in database. Foxflash software does not work on obd for BMW EDC17 ECUs.
zf8hp only on obd, ecu you need to do it on bench. ZF8HP over OBD is good job by Foxflash.
Do it on bench and also with 13++ voltage. Its very more safe just if you do it minimum 13volt.
Foxflash BMW edc17cp45 bench pinout
To read and write use the following driver:
→ BENCH TRICORE
→ BMW
→ TC1797 — BMW
→ EDC17 CP45
How to Read Write Iveco Trakker EDC17CV41 ECU with Foxflash
FOXFLASH User feedback:
Iveco trakker
Edc17cv41 ECU bench + DCU boot mode
ADBLUE OFF
Read
ok.
Writing ok.
Checksum by foxflash.
It runs great
Foxflash EDC17CV41 bench mode pinout
Some ECUs enter bench mode with the pinout below
Some ECUs enter bench mode with the pinout below
Foxflash EDC17CV41 boot tricore pinout
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1797
Foxflash Boot Mode for Nissan Juke EMS3155 ECU Programming
Foxflash read and write Nissan Juke 2016 with EMS3155 ECU on boot mode. Purchased a used EMS3155 ECU which I was able to read the password in boot mode. It’s possible to read the password in boot mode by various tool.
Read ok, write ok, checksum by foxflash.
Voltage supply 13V.
DTC off.
All good.
Check boot mode pinout here
http://www.pcmtuner.org/foxflash-read-and-write-renault-ems3155-in-boot/